Posts
DIY Hollow Out A Light Bulb
http://www.teamdroid.com/diy-hollow-out-a-light-bulb/
When I was growing up I had a keen interest in the
sciences. Mostly because of the cool gear that scientists used, you
know, beakers, flasks, Bunsen burners that sort of thing. Well, not only
did I not have the money for those sorts of thing but I had no idea
where to even buy them if I could. So I had to improvise. One of the
better improvisations I was able to do was to hollow out a light bulb
and use it for other things. The glass that makes the envelope of the
build is quite heat resistant and the screw base is good to attach
things to (even better if you can find old ones with brass bases, you
can solder to those). I made a number of small boilers in order to learn
about steam and distillation. I hope to show people that even if a bulb
burns out, it can still be useful.
Step 1
You will need some common tools, a screwdriver (regular)
and snips (or needle nose pliers). Use whatever bulb you have handy.
*CAUTION* Never use a fluorescent bulb for this project, no matter how
cool it looks. The powder used to coat the inside of them is made from
phosphor and is quite toxic. You’re also working with glass, so use eye
protection! You can’t see mine because I’m wearing them. You should also
use gloves or wrap the bulb in a towel just in case it breaks. Yeah,
you can’t see mine because i didn’t have any handy. So do as I say and
not as I do, got it?
Step 2
First, grip the little solder point and give it a good twist. You will free the brass contact and break one of the wires leading to the filament.
Step 3
Once the contact has been pulled out, carefully crack the glass insulator. The chips from this are quite pervasive, they get into just about anything in the area and they are razor sharp. Use caution.
Step 4
After the insulator has been removed you can see the inside supports of the filament and the fill hole. In the old days bulbs were evacuated of atmosphere to keep the filament from oxidising and burning through. Now days the glass envelope is back filled with an inert gas like argon. The keeps the filament from burning through and makes the bulbs safer.
Step 5
Use the screwdriver to break the fill tube.
Step 6
The fill tube could be saved for a later project if you wish.
Step 7
You can now shake the filament assembly out of the tube. If the tungsten wire is still intact you could probably find a good use for it. You could make another light bulb if your stuck for something to do I suppose.
Step 8
The bulb needs a good cleaning. This powder, is called kaolin and is pretty safe. You should still be careful and keep it away from your mouth and anything you might eat near.
Step 9
Mind the sharp bits of glass in the socket when doing this. If you have some stubborn bits inside of it that you can’t get to with this technique you can fill the bulb with a little salt and shake it about. this should scour the powder off the walls.
Step 10
